新闻资讯

News Center

current position: Home > News Center > COMMON PROBLEM

Although the nail making machine is easy to learn and understand, it is necessary to know the common problems!

2022-04-03 09:18:41
times

Although the nail making machine is easy to learn and understand, it is necessary to know the common problems!

The actual operation of the nail making machine is very simple, easy to understand and easy to understand, but there are still some unavoidable common problems that the workers must master in the whole process of application. The equipment belongs to the high-speed fitness exercise during the whole process of operation, so remember to carry out adjustment. After normal use, the cleaning work of the equipment should also be ensured, and the template of the equipment should be cleaned frequently. It is not allowed to use raw embroidered cables for production, because it will damage the normal operation of the equipment.

In the whole process of actual operation, it is very important to turn off the start of the incoming line. If you try to stop the operation of the nail making machine, you must first terminate the incoming line. Safety is very important. After the nail making machine is started, the worker must carefully observe and wait for the equipment to operate normally before turning the incoming wire nails. The sharpness of the nail knife endangers the quality of all nail products, and it is usually necessary to maintain the cleaning of the nail knife to prevent rust.

Nail making machine manufacturer

If it is observed that the temperature of each operating position has changed or an abnormal sound is heard during the entire operation of the equipment, the actual operation must be terminated immediately, the switching power supply must be cut off, and the equipment should be repaired afterwards. If the equipment is damaged, the original specification and model equipment should be replaced immediately, so as to maintain the normal operation of the second-hand nail machine, and also ensure that each friction part is well lubricated, and the inspection work should be carried out on time. The introduction of lubricating fluid, especially in the case of early application, requires a lot of lubricating in the first ten days. It is also important to understand that actual operation of the device is strictly prohibited with the protective cover removed.




Tags

Recently Viewed:

Copyright © copyright Yancheng Jingcheng Intelligent Equipment Co., Ltd 苏ICP备12030009号-1