Regulations for the installation of motors in mechanical equipment of nail making machines

Regulations for the installation of motors in mechanical equipment of nail making machines

In the mechanical equipment of the nail making machine, the motor must be installed, and the equipment of the motor cannot be ignored.

If the motor of the nail making machine is used, the motor that conforms to the specification and model of the nail making machine should be used. The output power of the nail making machine motor is too large, resulting in excess consumption. The starting or speed is very slow. According to the production efficiency of the nail making machine, it is 360 pieces per minute, and there are generally several types of motors on the market according to the speed ratio: 2-level motor 3000 rpm, 4-level motor 1500 rpm, 6-level motor 1000 rpm Rotation, 8-level motor 750 rpm, 10-level motor 600 rpm, 16-level motor 500 rpm. According to the speed ratio of each number of motors, the 8-stage motor is selected, and the speed reduction is carried out through a certain reducer, so that the speed ratio of the output of the reducer is 360 /min.

The motor of the nail making machine should not only be prepared for the output power, but also ensure that the motor graphics and wireframe are clear. It is also necessary to carry out relevant inspections on the cables used in the motor, such as weighing the single bag, and the cost-effective machinery and equipment are in compliance with the relevant regulations. The motor of the nail making machine starts to solve the problem of the power connection of the machine and equipment. If the quality of the motor is not up to standard, there will be a series of side effects, notably the temperature rise, which indicates that the heat dissipation of the motor is not good.

During the whole process of making the nail making machine, it is very likely that the top hat is tilted. If such a situation occurs, do you know how to adjust it? Here to teach you some common professional knowledge.

First, check the knife to see if the knife has a pointing axis, if not, adjust the point of the knife.

Second, if the floor plan of the nail die is uneven, the floor plan of the nail die must be adjusted.

Third, see if the mold shell is loose, if it is loose, please adjust it tightly.

Fourth, if the height of the nail knife is uneven, the position of the nail knife can be adjusted.